Grasp the WPAN cable connector and remove it from its socket on the logic board. The display cable connector is located directly below the right hinge. Grasp the display cable connector and remove it from its socket on the logic board. Slide the hinge covers outward from the computer and lift to remove them. Unscrew the two M2.5-by-5mm screws located on the hinge covers. Still grasping the pull tab, lift the keyboard at a slight angle and pull it towards the display to release it from its connector. Grasp the pull tab located at the top of the keyboard and gently lift the top of the keyboard from the computer. The screws were exposed when you removed the LED cover. Unscrew the two M2-by-3mm screws located the top of the keyboard. Close the display and turn the computer over on the work surface. Pry the clear LED cover from the computer by gently working the flat end of a plastic spudger around its perimeter. Turn the computer top-side up on the work surface and open the display. Slide the CD player to the right and out of its bay in the computer. Press the button that opens the CD player, which is referred to as the drive lever. Remove the security screw securing the CD player. An “H” on the hard drive indicates the locations of the screws. Remove the four M3-by-3mm screws securing the hard drive. Slide the bottom base assembly away from the computer and lift it up and away to remove. Grasp the two rubber feet located on the bottom base assembly. Unscrew the M2.5-by-5mm screw located in the center of the bottom base assembly. Close the computer and turn it top-side down, with the top of it facing away from you, on the microfiber cloth. Open the display and press the power button. Place the computer top-side down on a microfiber cloth.

Keyboard palm rest